In order to make the industrial chain aluminum row for the name of the firm surface, under normal circumstances, manufacturers will do oxidation processing process for some industrial chain aluminum row workpiece, so that the process consequences, not only is likely to develop the use of aluminum profile function, it may be very good to ensure the beauty of the workpiece, below, a simple introduction to the aluminum row after oxidation treatment need to pay attention to matters.

Relevant industry insiders said that the corresponding precautions are needed to understand, otherwise it will make the industrial chain aluminum profile workpiece use consequences are not good, and even cause the industrial chain aluminum profile caused early damage phenomenon. For example, hot water washing, the goal of hot water washing is aging film, but the level and time should be strictly controlled. The water temperature is too high, the film is thinner, the color becomes lighter, and the processing time is too long. The above similar problems will also appear.

The extrusion quality and yield of pure aluminum row also need to pay attention to the drying. Drying to dry is good, the hot water washing workpiece slanted on the shelf, to free water splashing down in the vertical direction, flow to the bottom corner of the water with towel suction, in accordance with this method of drying the film color is not affected.

At the same time, aluminum row after oxidation treatment, especially in the summer under such strong light, is to avoid exposure to the sun, if it is rainy or winter, you need to use the oven to bake it, the premise of the process is the temperature of 40-50 degrees Celsius, the time is 10-15min.

The above is the need to pay attention to the aluminum row after oxidation treatment, I hope to help you.